KeyCreator / Detail / Note / Hole Table / Hole Table Primary Units PaneHole Table Primary Units PaneThe pane shown below appears when you click Detail>Notes>Hole Table and then click Primary Units.
Dialog OptionsPrimary unitsDimensions are used to measure distance or size and, therefore, must be measured with units. This pane allows you to control units for the primary dimension value. Note that some of the fields on the Primary units pane have a Value button. This is a two-state button. When it is not pressed, the field beside it is used to specify a percentage of text height. For example, 0.75 means 75% of the text height. When pressed, the field beside it is used to specify an absolute value in terms of the part units. For example, when inches are the part units, 0.75 means ¾ of an inch. - - UnitsThe units in which the dimension is calculated. Available units are Inches, Millimeters, Feet, Centimeters, Yards, Meters and User. If you select User, then the Conversion factor field becomes available so you can define the User units. - - Conversion factorConversion from part units to the dimension units. For example, if the part is created in Inches and the dimensions are set to millimeters, the conversion factor is 25.4. The number of inches times 25.4 equals the number of millimeters. - - Display unit labelSelect to display the units label with the dimension value - - Unit labelThe label to display for the units - - Basic box gapThe space between the text box and the box of the basic tolerance box - - RepresentationThe representation formatting of the dimension value. Options are Decimal, Fractional or Feet/Inches. - - RoundoffUsed for Fractional and Feet/Inches display. This specifies to what precision the value is rounded. Options are 1, ½, ¼, 1/8, 1/16, 1/32, or 1/64. - - PrecisionThe number of digits displayed after the decimal character in decimal representation. There can be from 0 to 7 digits of precision displayed. - -Fraction separatorThe character that appears between the whole number and fractional number in a fractional display. You can select a space or a dash, or type the desired characters in this field. - - Decimal pointThe character to display for the decimal point in decimal representation - - Display leading zeroWhen selected, a leading zero is displayed for decimal values less than one. For example, a decimal representation of ¼ with leading zeros selected would be 0.25. - - Display trailing zerosWhen selected, zeros are displayed in the dimension value. For example, a decimal representation of ¼ with a precision of 4 and trailing zeros selected would be .2500. |